The Parker CP*OEM750X-10436 Drive is optimized to operate size 23 and 34 two phase permanent magnet hybrid step motors. It is a highperformance module around which the Original Equipment Manufacturer (OEM) can design a motion control system. The drive offers a basic set of features designed to meet the needs of most customers. It is compatible with all Compumotor indexers. The Parker CP*OEM750X-10436 is small and convenient to use. It installs with only two screws; the screws also provide grounding and captivate the cover. Its right-angle screw terminal allows sideby-side mounting, and its small footprint maximizes cabinet space. The snap-on molded cover is removable for drive configuration, and helps provide a barrier against environmental contamination. The drive is the same size as a 3U Eurorack card. Its standard 25 pin D-connector is compatible with universally available connectors.A typical system is shown below.     INPUT POWER The Parker CP*OEM750X-10436 requires a single external power supply. The drive accepts 24VDC to 75VDC for its power input. MOUNTING The drive is fully enclosed, and uses a heatplate technique to provide a heat dissipation path. You must attach the OEM750 to a suitable heat-dissipating mounting surface. DIP SWITCHES DIP switches are located inside the Parker CP*OEM750X-10436. During the installation procedure, you will set these DIP switches to scale the drive for resolution, waveform and other functions. INPUT & OUTPUT All communications take place through the Parker CP*OEM750X-10436's 25-pin D-connector. Available inputs and outputs are: • Step Input • Direction Input • Remote Input • Fault Output • Gear Shift Input   Our company--Rockss Automation Technology Co., Ltd. is a service company specializing in the sales and maintenance of automation products. We have a long-term stock of rare or discontinued international renowned automation accessories. We have a large inventory of Parker brand products, welcome to consult and purchase!